BWU4915Brake chopper 24 V, IP67
- Brake chopper for 24 V motorized rollers
- tolerated overvoltage up to 35 V
Product description
Brake chopper 24 V, housing depth 19 mm, IP67, connection for 1 x AUX profile cable, flat design, installation in cable duct possible (installation depth ≥ 19 mm), thermal fuse (overheating protection through clocking), tolerated overvoltage ≤ 35 V.
To limit the voltage feedback.
Technical data
|
Drive
If you cannot find your drive, please do not hesitate to contact us. Bihl+Wiedemann creates customized drive solutions with ASi for motorized rollers, DC motors and frequency inverters. | Brake chopper for 24 V motorized rollers |
| Inputs digital | no digital inputs |
| Outputs digital | no digital outputs |
|
Input voltage (sensor supply)
inputs are supplied by ASi or by AUX (24 V or 48 V auxiliary power). If supplied by ASi, inputs shall not be connected to earth or to external potential. | no input voltage |
|
Output voltage (actuator supply)
Electronic outputs are supplied by ASi or by AUX (24 V or 48 V auxiliary power). If supplied by ASi, outputs shall not be connected to earth or to external potential.
For relay outputs the relay contacts are initiated from ASi. The load circuit is powered externally as specified in the data sheet. | no output voltage |
| Connection | no connections |
|
Round cable
Under normal conditions (no bus termination or repeater), the permissible total length of the ASi segment is max. 100 m. The calculation should take into consideration that the length of the connection cable (round cable) for each connected passive distributor must be doubled. In the case of the active distributors (ASi modules) however only the one ASi profile cable is counted. | no |