BWU1722ASi Analog Output Module, IP65, M12, 4AO (0...20mA)
There is a successor to this article → BWU3105
The successor is not recommended for use as a spare part - Conditions for Selecting and Using the Successor Model
Product description
ASi Analog Output Module in IP65, width 90 mm, with 4 x M12 sockets, 4 analog outputs (0...20 mA), signal at pin1/pin3, output voltage/actuator supply out of AUX, periphery connection via 4 x M12 sockets, 5 poles, ASi connection via profile cable and piercing technology, 1 single address
The substructure module is not included in the scope of delivery.
Technical data
| Inputs digital | no digital inputs |
| Outputs digital | no digital outputs |
|
Input voltage (sensor supply)
inputs are supplied by ASi or by AUX (24 V or 48 V auxiliary power). If supplied by ASi, inputs shall not be connected to earth or to external potential. | no input voltage |
|
Output voltage (actuator supply)
Electronic outputs are supplied by ASi or by AUX (24 V or 48 V auxiliary power). If supplied by ASi, outputs shall not be connected to earth or to external potential.
For relay outputs the relay contacts are initiated from ASi. The load circuit is powered externally as specified in the data sheet. | out of AUX |
| Connection | 4 x M12 sockets, 5 poles |
|
Round cable
Under normal conditions (no bus termination or repeater), the permissible total length of the ASi segment is max. 100 m. The calculation should take into consideration that the length of the connection cable (round cable) for each connected passive distributor must be doubled. In the case of the active distributors (ASi modules) however only the one ASi profile cable is counted. | no |
|
ASi address
Bihl+Wiedemann offers modules with AB address, single address or ASi-5 address. In some cases, ASi modules can occupy several (different) addresses. Mixed operation of modules with different addressing in the same ASi circuit is permitted. | 1 Single address |
